Electronics Mechanic Technician Questions

Attempt Free Electronics Mechanic Technician Questions Here. Read The Important Electronics Mechanic Technician MCQ From Below.

Electronics Mechanic Technician Questions Mostly Asked MCQ PDF

Here we are providing mostly asked MCQ PDF of Electronics Mechanic Technician stage exam, It will be provide help to aspirants who are going to appear this exam.

Question-1.Electrical braking preferred in industries is

1. None of these
2. Plugging
3. Regenerate breaking
4. Dynamic breaking

Answer-Regenerate breaking

Question-2. In Hand off

1. Process of transferring the call to the new base station
2. New channel allocation is done
3. Transfers the call
4. All of these

Answer -All of these

Question-3.Following is used an output device on a ladder diagram

1. Proximity sensor
2. Detent switch
3. All of these
4. Relay

Answer-Relay

Question-4.In PLC mounting rack s used for mouning

1. I/ O Module
2. Processor
3. All of these
4. Communication module

Answer -All of these

Question-5.The minimum spectrum allocation required for W-CDMA is

1. 2MH
2. 100KH
3. 5MH
4. 500KH

Answer-5MH

Electronics Mechanic Technician Questions

Question-6.The shape of the cellular region for maximum radio coverage is

1. Hexagon
2. Circular
3. Oval
4. Square

Answer-Hexagon

Question-7.The process of transferring a mobile station from one base station to another is

1. MSC
2. Forward channel
3. Roamer
4. Hand off

Answer -Hand off

Question-8.Type of electric drive used in cranes

1. Individual
2. Both Individual & Group
3. Group
4. Multi motor

Answer-Multi motor

Question-9.Rotating magnetic field is produced in a

1. Three phase induction motor
2. DC series motor
3. AC series motor
4. Single-phase induction motor

Answer-Three phase induction motor

Question-10.The starting torque in a single-phase induction motor is

1. Zero
2. High
3. Low
4. Very low

Answer-Zero

Electronics Mechanic Technician Questions

Question-11.The lubricator in a pneumatic circuit is the

1. Last element in line
2. Second element in line
3. First element in line
4. Third element in line

Answer-Last element in line

Question-12.In pneumatic system, AND gate is also known as

1. None of these
2. Check valve
3. Shuttle valve
4. Dual pressure valve

Answer-Dual pressure valve

Question-13. If in induction machine is run at above synchronous speed, it acts as

1. An induction motor
2. An induction generator
3. None of these
4. A synchronous motor

Answer-An induction generator

Question-14.The capability of convent on relay systems for complex operations is _________that of the PLCs.

1. Unpredictable as
2. As good as
3. Poor than
4. Excellent than

Answer-Poor than

Question-15.Slip of an induct on motor increases with

1. Decrease in current and increase in torque
2. Decrease in current and torque
3. Increase in current and decrease in torque
4. Increase in current and torque

Answer-Increase In current and torque

Electronics Mechanic Technician Questions

Question-16.Carrier frequency of a TV remote control is in the range

1. Of infrared
2. Less than 1 GH
3. Less than 100 MH
4. Less than 2 GH

Answer-Of infrared

Question-17.Static convergence is done of the screen

1. Center
2. Edges
3. Right
4. Left

Answer-Center

Question-18. If the value of error Increases, the changing speed of controller output

1. Increases
2. Decrease
3. Cannot say
4. Remains constant

Answer-Remains constant

Question-19.AC power in a load can be controlled by using