ONLINE MCQ EE AND ECE-CONTROL SYSTEMS 2
Category –EE Online Test
Telegram-Join Us On Telegram
Attempt Free ONLINE MCQ EE AND ECE-CONTROL SYSTEMS 2 Here. Read The Important Electrical MCQ From Below.
1. An impulse function is a derivative of __ function
a) Parabolic
b) Step
c) Ramp
d) Linear
Answer b
2. The required for the response to rise and stay within the tolerance band is called as:
a) Rise time
b) Pickup time
c) Settling time
d) Transient time
Answer c
ONLINE MCQ EE AND ECE-CONTROL SYSTEMS 2
3. The time required for the response to rise from 10% to 90% of the final value for over damped systems and 0 to 100% of the final value for under damped systems is called the:
a) Rise time
b) Pickup time
c) Settling time
d) Transient time
Answer a
4. Control systems are normally designed with a damping factor:
a) Less than unity
b) Of unity
c)Â Of Zero
d) More than unity
Answer b
5. A signal whose value changes from one level to other level in no time is known as __ signal
a) Impulse
b) Step
c) Ramp
d) Parabolic
Answer b
6. The overshoot (an indication of the largest error between the actual and desired output) is the ratio of:
a) Transient error to peak error
b) Dynamic error to peak error
c) Maximum overshoot to final desired value
d) None of the above
Answer c
ONLINE MCQ EE AND ECE-CONTROL SYSTEMS 2
7. Error constants of the system are measure of:
a) Relative stability
b) Transient state response
c) Steady state response
d) Steady state as well as transient state response
Answer b
8. ___ gives indication how fast the system tends to attain the final value
a) Delay time
b) Rise time
c) Time constant
d) Settling time
Answer b
9. A signal flow graph is a:
a) Special type of graph for analyzing the modern control system
b) Pictorial representation of the simultaneous equations describing a system
c) Polar graph
d) Log log graph
Answer b
10. The basic property of the signal flow graph is/are:
a) It is applicable to linear system only
b) Nodes are arranged from left to right in a sequence
c) Signals travel along branches only in the marked direction and is multiplied by the branch again
d) The algebraic equations must be in the form of cause and effect relationship
e) All the above
Answer e
ONLINE MCQ EE AND ECE-CONTROL SYSTEMS 2
