Measurements and Instrumentation Part 6
Category –EE Online Test
Telegram-Join Us On Telegram
Attempt Free Measurements and Instrumentation Part 6 Here. Read The Important Electrical MCQ From Below.
(a) German silver
(b) Platinum silver
(c) Silicon bronze
(d) Phosphor bronze
Answer
[2] A moving coil instrument is used as an ohmmeter. The indicating scale of the meter will be
(a) Hyperbolic
(b) Logarithmic
(c) Linear
(d) Inverse linear
Answer
Measurements and Instrumentation Part 6
[3] For high accuracy the meter has
(a) Supporting mirror
(b) Hand drawn scale
(c) Printed scale
(d) Scale with sharp pointer
Answer
[4] Among the voltages to various electrodes in a CRT the voltage is the highest on
(a) Aquadag
(b) Focusing anode
(c) Deflection plates
(d) PD anode
Answer
[5] In a free running oscilloscope the horizontal deflection system is driven by a …….. waveform
(a) Step
(b) Impulse
(c) Ramp
(d) DC
Answer
Measurements and Instrumentation Part 6
[6] A Lissajous patterns are used to measure
(a) Voltage and frequency
(b) Frequency and Phase shift
(c) Frequency and amplitude distortion
(d) Amplitude and flux
Answer
[7] The shunt used in milliammeter
(a) will extend the range and reduce the meter resistance
(b) will extend the range and increase the meter resistance
(c) will decrease the range and meter resistance
(d) will not affect the meter
Answer
[8] The electrostatic instruments can be used without serious loss of accuracy upto ……… frequency
(a) 100Hz
(b) 100kHz
(c) 1 MHz
(d) 10MHz
Answer
Measurements and Instrumentation Part 6
[9] In the case of PMMC rectifier type instruments, the deflecting torque is proportional to
(a) Average value of AC current
(b) RMS of AC
(c) Instantaneous value
(d) Peak value
Answer
[10] Inductance and capacitance in the electrostatic system of units has the dimensions of
(a) mass
(b) mass-time
(c) mass length/time
(d) length
Answer
[11] For the indicating instrument the preferred damping condition is
(a) Critically damped
(b) a damping coefficient of 0.8 to 1
(c) Overdamped
(d) Underdamped
Answer
Measurements and Instrumentation Part 6
[12] One international ohm is equal to
(a) 1.00049 absolute ohm
(b) 0.99951 absolute ohm
(c) 0.969 absolute ohm
(d) 1.049 absolute ohm
Answer