Circuits and Circuit Theory Part 3
Category –EE Online Test
Telegram-Join Us On Telegram
Attempt Free Circuits and Circuit Theory Part 3 Here. Read The Important Electrical MCQ From Below.
1. Which of the following refers to a parallel circuit?
(A) The current through each element is same
(B) The voltage across element is in proportion to it’s resistance value
(C) The equivalent resistance is greater than any one of the resistors
(D) The current through any one element is less than the source current
Correct Answer
2. The frequency of domestic power supply in India is
(A) 200 Hz
(B) 100 Hz
(C) 60 Hz
(D) 50 Hz
Correct Answer
Circuits and Circuit Theory Part 3
3. The frequency of an alternating current is
(A) The speed with which the alternator runs
(B) The number of cycles generated in one minute
(C) The number of waves passing through a point in one second
(D) The number of electrons passing through a point in one second
Correct Answer
4. In a pure inductive circuit if the supply frequency is reduced to 1/2, the current will
(A) Be reduced by half
(B) Be doubled
(C) Be four times as high
(D) Be reduced to one fourth
Correct Answer
Circuits and Circuit Theory Part 3
5. A sine wave has a frequency of 50 Hz. Its angular frequency is _______ radian/second.
(A) 100 n
(B) 50 jt
(C) 25 JT
(D) 5 n
Correct Answer
6. Two waves of the same frequency have opposite phase when the phase angle between them is
(A) 360°
(B) 180°
(C) 90°
(D) 0°
Correct Answer
7. In a pure inductive circuit
(A) The current is in phase with the voltage
(B) The current lags behind the voltage by 90°
(C) The current leads the voltage by 90°
(D) The current can lead or lag by 90°
Correct Answer
Circuits and Circuit Theory Part 3
8. The time constant of a series R-C circuit is given by
(A) R/C
(B) RC2
(C) RC
(D) R2C
Correct Answer
9. A heater is rated as 230 V, 10 kW, A.C. The value 230 V refers to
(A) Average voltage
(B) r.m.s. voltage
(C) Peak voltage
(D) None of the above
Correct Answer
10. Apaporis
(A) A line which represents the magnitude and phase of an alternating quantity
(B) A line representing the magnitude and direction of an alternating quantity
(C) A colored tag or band for distinction between different phases of a 3-phase supply
(D) An instrument used for measuring phases of an unbalanced 3-phase load
Correct Answer
Circuits and Circuit Theory Part 3
