Transmission And Distribution Part 10

Transmission And Distribution Part 10

Transmission And Distribution Part 10

Category –EE Online Test

Telegram-Join Us On Telegram

Attempt Free Transmission And Distribution Part 10 Here. Read The Important Electrical MCQ From Below.

Q1. There is a greater possibility of occurrence of corona during

A.  dry weather
B.  winter
C.  summer heat
D.  humid weather

Ans. D

Q2. In A.C.S.R. conductors, the insulation between aluminum and steel conductors is

A.  insulin
B.  bitumen
C.  varnish
D.  no insulation is required

Ans. D

Q3. Corona usually occurs when the electrostatic stress in air around the conductor exceeds

A.  6.6 kV (r.m.s. value)/cm
B.  11 kV (r.m.s. value)/cm
C.  22 kV (maximum value)/cm
D.  30 kV (maximum value)/cm

Ans. D

Q4. In a tap changing transformer, the tappings are provided on

A.  primary winding
B.  secondary winding
C.  high voltage winding
D.  any of the above

Ans. B

Transmission And Distribution Part 10

Q5. The angular displacement between two interconnected stations is mainly due to

A.  armature reactance of both alternators
B.  reactance of the interconnector
C.  synchronous reactance of both the alternators
D.  all of the above

Ans. B

Q6. The skin effect of a conductor will reduce as the

A.  resistivity of conductor material increases
B.  permeability of conductor material increases
C.  diameter increases
D.  frequency increases

Ans. A

Q7. Which of the following distribution systems is the most economical ?

A.  A.C. 1-phase system
B.  A.C. 3-phase 3 wire system
C.  A.C. 3-phase 4 wire system
D.  Direct current system

Ans. D

Q8. Power loss due to corona is not directly proportional to

A.  spacing between conductors
B.  supply voltage frequency
C.  phase-neutral voltage
D.  all of the above

Ans. A

Transmission And Distribution Part 10

Q9. In the design of a distributor which of the following is the major consideration ?

A.  Voltage drop
B.  Current carrying capacity
C.  Frequency
D.  kVA of system

Ans. A

Q10. Which of the following cause transient disturbances ?

A.  Faults
B.  Load variations
C.  Switching operations
D.  Any of the above

Ans. D