SSC JE Electrical Important MCQ Part 5
Category –SSC Online Test
Telegram-Join Us On Telegram
Attempt Free SSC JE Electrical Important MCQ Part 5 Here. Read The Important GK MCQ From Below.
SSC JE Electrical Important MCQ PDF Part 5
Note-Download Link Of PDF Given At End Of Post
1.What is the expansion of DPIC switch
A) Digital Pole Iron Clad Switch
B) Double Pole Iron Clad Switch
C) Double Phase Induction Core Switch
D) Dual Phase Iron Clad Switch
Answer : B (DPIC stands for Double Pole Iron Clad Switch)
2.The number of magnetic starter poles refer to the
A) Number of north poles
B) Number of control contacts
C) Number of south poles
D) Number of power load contacts
SSC JE Electrical Important MCQ Part 5
Answer : D (The number of poles refers to the number of power contacts determined by the electrical supply service. E.g., in a three-phase, three-wire system, a three-pole starter is required)
3.If an alternator winding has a fractional pitch of 5/6, the coil span is _______ degrees.
A) 180
B) 60
C) 300
D) 150
Answer : D (Coil spam=180⁰×5/6=150⁰)
4.Ammeter should always have a
A) Low resistance
B) High voltage
C) Low voltage
D) High resistance
Answer : A
5.Reverse Power flow relays are used for the protection of _______
A) Generating stations
B) Transmission stations
C) Transformers
D) Domestic power supplies
Answer : A (Reverse Power Relay is a directional protective relay that prevents/protect the generator from motoring effect (going to reverse direction). It is used where generator runs in parallel with other utility or generator)
SSC JE Electrical Important MCQ Part 5
6.Which of the following wiring systems is normally used in domestic purposes
A) Lead Sheathed
B) Conduit
C) Batten
D) Capping
Answer : B (Conduit wiring system mostly used in residential and light-commercial wiring systems, including common applications)
7.Which of the following types of wiring are aesthetically appealing
A) Conduit concealed wiring
B) Batten wiring
C) Cleat wiring
D) Conduit surface wiring
Answer : A (Concealed Conduit Electrical Wiring systems are the most popular, aesthetically appealing, and most common type of House Electrical wiring used)
8.What is the average power of an AC circuit
A) VI Sin²Φ
B) VI CosΦ
C) VI SinΦ
D) Zero
Answer : B
SSC JE Electrical Important MCQ Part 5
9.The knee voltage for a germanium diode is
A) 0.3 V
B) 0.1 V
C) 0.7 V
D) 0.8 V
Answer : A (The value of knee voltage for silicon diode is 0.7 V and for germanium diode 0.3 V)
10.The minimum number of diodes needed for a bridge rectifier is
A) Five
B) Four
C) Two
D) Six
Answer : B
11.Why are batteries connected in parallel
A) To increase the efficiency
B) To increase the current capacity
C) To increase the voltage rating
D) To increase the life of the batteries
Answer : B
SSC JE Electrical Important MCQ Part 5
12.A winding which has equal number of slots and poles is called
A) Full pitch winding
B) Concentrated winding
C) Short pitch winding
D) Distributed winding
Answer : B (Concentrated winding:Concentrated winding is employed where number of slots on the armature is equal to number of poles in the machine)
13.A semiconductor device which acts like a diode and two transistors is
A) MOSFET
B) TRIAC
C) UJT
D) DIAC
Answer : B (The triac is similar in operation to two transistor connceted in reverse parallel but using a common gate. The triac can conduct in both direction)
14.The Tellegen’s theorem can be applied to
A) Passive & active networks
B) All of these
C) Hysteric and non-hysteric networks
D) Linear & non-linear networks
Answer : B
SSC JE Electrical Important MCQ Part 5
15.The connection of a Zener diode in a circuit is always
A) Positively biased
B) Reverse biased
C) In series
D) Forward biased
Answer : B
16.Induction motor works on the principle of
A) Chemical effect
B) Heating effect
C) Electromagnetic induction
D) Electrostatic effect
Answer : C
17.What is the length of a 40 watt tube
A) 0.6 m
B) 1.5 m
C) 2 m
D) 1.2 m
SSC JE Electrical Important MCQ Part 5
Answer : D (20 watt-2 ft (610 mm),40 watt-4 ft (1219 mm))
18.A circuit breaker normally operates
A) Whenever a fault occurs in the line
B) When the power is to be supplied
C) When the switch is to be put on
D) When the line is to be tested
Answer : A
19.Solder is an alloy of
A) Lead and copper
B) Lead and silver
C) Lead and tin
D) Lead and sodium
Answer : C
20.According to weber’s molecular theory of magnetism, when a magnetic material is magnetised, its molecules are forced along a __________.
A) Parallel line
B) Straight line
C) Circular line
D) Spherical line
Answer : B (According to Weber’s Molecular Theory of magnetism, when a magnetic material is magnetised, its molecules are forced along a straight line)
SSC JE Electrical Important MCQ Part 5
