Electric Machine Design PART 9 ONLINE Multiple Choice Questions

Electric Machine Design PART 9

Electric Machine Design PART 9

Category –EE Online Test

Telegram-Join Us On Telegram

Attempt Free Electric Machine Design PART 9 Here. Read The Important Electrical MCQ From Below.

121. In case of thyrite the resistance is
(A) inversely proportional to the applied voltage
(B) directly proportional to the square of the applied voltage
(C) directly proportional to the cube of the applied voltage
(D) none of the above.Get Answer

122. The ‘hum’ in a transformer is due to
(A) vibrations in cooling oil
(B) vibration in laminations
(C) sinusoidal voltage waveform
(D) all of the above.

Get Answer

123. Which test is conducted on transformers to check its ability to withstand the transient voltages due to lightening etc. ?
(A) Induced over voltage test
(B) Partial discharge test
(C) Impulse test
(D) Any of the above.

Get Answer

Electric Machine Design PART 9

124. The density of transformer oil is around
(A)1.2gm / cc
(B) 1.0 gm/cc
(C) 0.95 gm/cc
(D)J0.80 gm/cc.

Get Answer

125. The flash point of transformer oil is usually
(A) 50°C
(B) 75°C
(C) 160°C
(D) 150°C.

Get Answer

126. The maximum permissible water content in transformer oil is
(A) zero
(B) 10 ppm
(C) 25 ppm
(D) 50 ppm.

Get Answer

127. The kinetic viscosity of transformer oil should be
(A) 5 cst
(B) 2.5 cst
(C) 50 cst
(D) 125 cst.

Get Answer

Electric Machine Design PART 9

128. The maximum pour point of transformer oil should be
(A)10°C
(B) 0°C
(C) 4°C
(D) 14.4°C.

Get Answer

129. The dielectric strength of transformer oil’ should not be less than
(A)10kV
(B) 20 kV
(C) 30 kV
(D) 50 kV.

Get Answer

130. The specific resistance of the transformer oil is of the order of
(A) 104 ohms cm
(B) 106 ohms cm
(C) 1012 ohms cm
(D) 1024 ohms cm.

Get Answer

131. Phase spread in ac machines is almost always
(A) 90°
(B) 60°
(C)120°
(D) 50°

Get Answer

Electric Machine Design PART 9

132. The electric motor provided on refrigerators is usually
(A) open type
(B) protected type
(C) screen protected type
(D) totally enclosed type.

Get Answer

133. Flame proof motors are used in
(A) explosive atmosphere
(B) moisture free atmosphere
(C) dust free atmosphere
(D) moisture and dust free atmosphere.

Get Answer

134. Which of the following machine is invariably provided with forced ventilation ?
(A) Fractional horse power slow speed motor
(B) Fractional horse power high speed motor
(C) Hermetically sealed motor of refrigerator
(D) 50 MW generator in a power plant.

Get Answer

Electric Machine Design PART 9

135. Since hydrogen is 14 times lighter than air its use as cooling medium is mainly to
(A) reduces noise
(B) reduces windage losses
(C) increase maintenance
(D) none of the above.

Get Answer