Electric Machine Design PART 6
Category –EE Online Test
Telegram-Join Us On Telegram
Attempt Free Electric Machine Design PART 6 Here. Read The Important Electrical MCQ From Below.
(A) D
(B) D2
(C) 1/D
(D) 1/D2Get Answer
77. The force-stroke curve for a lifting magnet will be of the shape shown in
(A) figure A
(B) figure B
(C) figure C
(D) figure D.
Get Answer
Electric Machine Design PART 6
78. When B is the flux density ; A is the area of the working gap and μ is the permeability, the force exerted by the
attractive type magnets is given by
(A) μA / 2B
(B μ B / A2
(C) A2B1/ 2μ
(D) B A2/ 2μ
Get Answer
79. Transformer-core laminations are made of
(A) cast iron
(B) wrought iron
(C) silicon steel
(D) cast steel.
Get Answer
80. When commutation is obtained by increasing the current density at the leading edge and decreasing the same at trailing edge, it is known as
(A) under commutation
(B) over commutation
(C) straight commutation
(D) sinusoidal commutation.
Get Answer
Electric Machine Design PART 6
81. Skewing of rotor slots helps in
(A) improving beat transfer
(B) reducing noise
(C) suppressing undesirable harmonics
(D) all of the above.
Get Answer
82. The harmonics in rotating machines are generated due to
(A) non-sinusoidal field form
(B) slotting of the stator core
(C) both (A) and (B) above
(D) none of the above.
Get Answer
83. The effect of harmonics in rotating machines can be minimized by
(A) use of longer air gap
(B) skewing the poles
(C) use of distributed winding
(D) all of the above.
Get Answer
84. Which of the following measure will not help in reducing the effect of harmonics ?
(A) connecting 3 phase winding in star or delta without neutral
(B) use of short pitch coils or fractional slot windings
(C) chamfering the pole shoes of salient pole machines
(D) reducing the number of slots per pole per phase.
Get Answer
85. In dc machines the number of poles is generally decided by
(A) frequency of flux reversals
(B) weight of iron parts
(C) weight of copper
(D) all of the above.
Get Answer
Electric Machine Design PART 6
86. In dc machines by increasing the number of poles, all of the following reduce except:
(A) weight of copper
(B) weight of iron parts
(C) frequency of flux reversals
(D) overall size of the machine.
Get Answer
87. Transformer action requires a
(A) constant magnetic flux
(B) increasing magnetic flux
(C) alternating magnetic flux
(D) alternating electric flux.
Get Answer
88. Which component of the no load current of the transformer is opposite in phase to the induced emf ?
(A) magnetizing component
(B) core loss component
(C) both (A) and (B) above
(D) none of the above.
Get Answer
89. In transformers, the cylindrical winding with rectangular conductors is generally used for
(A) low voltage winding
(B) high voltage winding
(C) tertiary voltage winding
(D) any of the above.
Get Answer
Electric Machine Design PART 6
90. Cylindrical winding on transformers is generally not used beyond
(A) 6 kV
(B) 30 kV
(C) 66 kV
(D) 132 kV.
Get Answer
