Electric Machine Design PART 15
Category –EE Online Test
Telegram-Join Us On Telegram
Attempt Free Electric Machine Design PART 15 Here. Read The Important Electrical MCQ From Below.
211. In case of transformers, with increasing frequency
(A) copper losses reduce but efficiency increases
(B) copper losses increase but efficiency decreases
(C) both copper losses and efficiency increase
(D) copper losses remain unaffected while efficiency increases.
Get Answer
212. The regulation of a transformer is least affected by changes in frequency at
(A) leading power factor
(B) lagging power factor
(C) unity power factor
(D) all of the above.
Get Answer
213. In case of induction motor, with increase in supply voltage, which of the following increases ?
(A) Power factor
(B) Slip
(C) Torque
(D) All of the above.
Get Answer
Electric Machine Design PART 15
214. In most AC machines, it is usually a standard practice to use
(A) fractional slot winding With full-pitch coils
(B) fractional slot winding with chorded coils
(C) integral slot winding with chorded coils
(D) integral slot winding with full pitch coils.
Get Answer
215. In a transformer iron losses vary as __________ of voltage
(A) inverse
(B) inverse square
(C) square
(D) cube.
Get Answer
216. In case of distribution transformers, at fractional loads
(A) with increase in voltage efficiency decreases
(B) with increase in voltage efficiency increases
(C) with decrease in voltage efficiency decreases
Get Answer
217. In case of transformers regulation varies as
(A) inverse of voltage
(B) square of voltage
(C) inverse square of voltage
(D) voltage.
Get Answer
Electric Machine Design PART 15
218. In a transformer, with change in frequency
(A) copper losses increase
(B) copper losses decrease
(C) copper losses remain unchanged.
Get Answer
219. Distribution transformer has core losses
(A) > copper losses
(B) = copper losses
(C) ∞ copper losses
(D) = 1/2 copper losses.
Get Answer
220. If a synchronous motor fails to start, the probable cause could be
(A) low voltage
(B) too much load at starting
(C) single phasing
(D) any of the above.
Get Answer
221. In case a synchronous motor starts but fails to develop full torque, the probable cause could be
(A) low excited voltage
(B) reverse field winding
(C) open or short circuit
(D) any of the above.
Get Answer
222. If a DC machine gives shock the probable cause could be
(A) armature field coils or brush holders earthed
(B) weak or leaky insulation
(C) loose earth wire
(D) all of the above.
Get Answer
Electric Machine Design PART 15
223. If a DC motor stops after running for some time, the probable cause could be any of the following EXCEPT:
(A) Weak or no field
(B) Brushes ahead of neutral
(C) Insufficient power supply
(D) Insufficient torque developed.
Get Answer
224. If fuse blows at the starting of a DC motor the probable cause could be
(A) low capacity of the fuse
(B) overload
(C) short circuit in the starter resistance
(D) any of the above.
Get Answer
225. Sound in a DC motor may be due to
(A) unequal resistance of the armature and field coils
(B) loose fittings of the field core with yoke or frame
(C) improper fitting of the side covers
(D) any of the above.
Get Answer
Electric Machine Design PART 15
