Electric Machine Design PART 13
Category –EE Online Test
Telegram-Join Us On Telegram
Attempt Free Electric Machine Design PART 13 Here. Read The Important Electrical MCQ From Below.
181. The output of a rotating electrical machine is limited by
(A) size of the machine
(B) peripheral velocity
(C) temperature rise
(D) none of the above.Get Answer
182. The hum in the transformer is due to
(A) transformer winding
(B) magnetostriction
(C) transformer oil
(D) tank walls.
Get Answer
Electric Machine Design PART 13
183. Turbo alternators are characterized by
(A) short diameters and great axial lengths
(B) short diameters and narrow axial lengths
(C) large diameters and narrow axial lengths
(D) large diameters and great axial lengths.
Get Answer
184. Short circuit ratio for turbo-alternators is usually
(A) 0.1 to 0.2
(B) 0.2 to 0.4
(C) 0.5 to 0.7
(D) 0.8 to 0.95.
Get Answer
185. A synchronous machine having large length of the air gap will have
(A) higher noise level
(B) smaller unbalanced magnetic pull
(C) lower limit of stability
(D) higher value of inherent regulation.
Get Answer
186. Damper windings are provided in synchronous machines to
(A) damp out rotor oscillations
(B) reduce the over-voltages under abnormal conditions
(C) facilitate starting
(D) all of the above.
Get Answer
Electric Machine Design PART 13
187. The use of salient poles on high speed alternators will cause
(A) excessive windage loss and excessive noise
(B) reduced windage loss and low noise
(C) reduced windage loss but excessive noise
(D) excessive windage loss but reduced noise.
Get Answer
188. Arc welding transformer is basically a
(A) frequency changing device
(B) step up transformer
(C) step down transformer
(D) current transformer.
Get Answer
189. The output voltage of arc welding transformer is usually
(A) 10 to 30 V
(B) 35 to 55 V
(C) 55 to 65 V
(D) 110 to 135 V.
Get Answer
190. A welding transformer should have
(A) drooping voltage-current characteristics
(B) open circuit voltage less than 80 V
(C) current controlled continuously over the full range
(D) all of the above.
Get Answer
Electric Machine Design PART 13
191. The drooping characteristics of a welding transformer are usually obtained by
(A) using series reactance
(B) adopting oil cooling
(C) multiple tapings on secondary
(D) none of the above.
Get Answer
192. The power factor of a welding transformer is usually
(A) 1.0
(B) high
(C) 0.5
(D) very low.
Get Answer
193. For the load cycle shown in the figure, the rating of the motor should be
(A) 600 kW
(B) 350 kW
(C) 300 kW
(D) 275 kW.
Get Answer
Electric Machine Design PART 13
Questions 194 to 196 refer to data below :
Three cores made up of iron, aluminium and wood have the same
dimensions and are wound with the same number of turns. All these are
fed from the same voltage source at a fixed frequency.
194. The materials in order of decreasing magnetizing currents will be
(A) wood, aluminium, iron
(B) wood, iron, aluminium
(C) iron, wood, aluminium
(D) iron, aluminium, wood.
Get Answer
195. The materials in order of decreasing
hysteresis loss will be
(A) wood, aluminium and iron
(B) iron, aluminium, wood
(C) iron, wood, aluminium
(D) aluminium, iron, wood.
Get Answer
Electric Machine Design PART 13
