Electric Machine Design PART 12
Category –EE Online Test
Telegram-Join Us On Telegram
Attempt Free Electric Machine Design PART 12 Here. Read The Important Electrical MCQ From Below.
(A) high operating speeds
(B) asynchronous-speed operation
(C) pulsating torque
(D) small air gap.Get Answer
167. The average value of specific electric loading of induction motors is in the range
(A) 5 to 50 ampere conductors/meter
(B) 50 to 450 ampere conductors/meter
(C) 500 to 4500 ampere conductors/meter
(D) 5000 to 45000 ampere conductors/meter.
Get Answer
168. In case of induction motors the ratio of length to pole pitch for minimum cost, is taken as
(A)1.0
(B) 1.5 to 2
(C) 2 to 3
(D) 3 to 5.
Get Answer
Electric Machine Design PART 12
169. In case of induction motors, the ratio of length to pole pitch for good efficiency is taken as
(A) 1.0
(B) 1.5
(C) 2.0
(D) 5.0.
Get Answer
170. For small induction motors, the ratio of length to pole pitch is taken as
(A) 0.6
(B) 1.5
(C) 1.5
(D) 2.0.
Get Answer
171. The number of parallel paths in an integral slot winding with P poles are
(A) P
(B) 2P
(C) P/2
(D) P/4.
Get Answer
172. The use of double squirrel cage winding on the rotor provides
(A) low noise
(B) reduced starting torque
(C) a large starting torque
(D) higher efficiency.
Get Answer
Electric Machine Design PART 12
173. By providing deep narrow slots in the rotor punching in induction motor
(A) starting torque can be increased
(B) running torque can be reduced
(C) efficiency can be improved
(D) none of the above.
Get Answer
174. In induction motor if the number of rotor slots is equal to the stator slots then
(A) the motor will run smoothly
(B) the motor will mil at zero slip
(C) the noise level will be low
(D) the motor may refuse to start.
Get Answer
175. A __________ value of magnetizing current gives __________ power factor
(A) large……..poor
(B) large ……… better
(C) smaller……..poor
(D) smaller …….. larger.
Get Answer
176. Friction and windage loss in induction motor is usually
(A) 0.1% of the rated output
(B) 1% of the rated output
(C) 5% of the rated output
(D) 10% of the rated output.
Get Answer
Electric Machine Design PART 12
177. In case of double cage rotor the upper cage which is near to the air gap is made of
(A) electrolytic copper
(B) annealed copper
(C) brass
(D) steel.
Get Answer
178. Losses due to harmonic currents produced in the cage rotor winding can be reduced by
(A) using skewed rotor
(B) using chorded stator winding
(C) proper slot combination of rotor and stator
(D) any of the above.
Get Answer
179. In squirrel cage motors, skin effect occurs in
(A) stator winding
(B) rotor winding
(C) both (A) and (B) above
(D) none of the above.
Get Answer
180. For a 3 φ fractional slot winding with P poles the number of parallel paths is
(A) P
(B) 2P
(C) P/2
(D) none of these.
Get Answer
Electric Machine Design PART 12
