ECIL GET Electrical And Electronics 2010 and 2012 Questions Paper Analysis With Important Topics

ECIL GET Electrical And Electronics 2010

ECIL GET Electrical And Electronics (EEE) 2010 and 2012 Questions Paper Analysis With Important Topics

Here I am writing review of ECIL GET EEE 2010 and 2012 exam, I am thanks full to student who have written review of 2010 and 2012 exam on various portal. These student have attempted ECIL GET Exam 2010 and 2012 on the basis of theirs review here I am writing a complete review.

According to review in 2010 and 2012 exam pattern as following

Total no of questions-50 (Only technical questions)

Total Marks-150 each questions 3 marks

Total Times-120 Minutes

Negative Marking-One marks for each wrong answers

That time exam was easy and competition was also easy and there is sufficient time for solving 50 questions, But in GET 2017 Exam will be not easy because there is 100 questions in 90 minutes but there will be no negative marking .

Expected this time exam will be also easy but due large no of candidate and less time, Competition will be high.

I hope my this review will provide great to ECIL GET 2017 Aspirants.

ECIL GET Electrical And Electronics 2010

Important Topics Have Asked In 2010 And 2012 GET Exam-

Here I am providing important topics which have asked in 2010 and 2012 exam based on student review.

1.Analog Electronics (Opams)

2.Electrical Machine (Important topics Transformer, Synchronous Motor)

3.Digital circuit (Important topics ADC & DAC)

4.Networks Analysis(Networks Theorems)

5.Control System (1-2 questions)

6.Signal System (1-2 questions)

7.Communication (1-2 questions)

8.Basic Electrical (Resonance, RLC Circuit)

9.Measurement (CRO)

ECIL GET Electrical And Electronics 2010

10.Power system (Protection and distribution )

12.Microprocessors

Questions Have Asked In 2010 And 2012 GET Exam-

Important Questions which have asked in GET 2010 and 2012 exam as following

A charge of 1 Coulomb is moved from potential of 80v to 20v.The work done in moving the charge
A 200KW thermal plant running giving an avg output of 180kw.when charges Rs.2 per unit. What could be the cost of generation.
Fastest A/D converter
Which GATE used as a Comparator
One question from Lagging-leading?

ECIL GET Electrical And Electronics 2010

Problem to calculate Parallel resonance of RLC circuit, in which R,LC values were given.
Simplifications of Boolean Algebra like-x(x+y) and 1+x
Calculate DC gain of 10/((s+2)(s+1))
Calculate Steady state error for step input when function is 1/(1+sT)
When two’s compliment of two numbers multiplied they lie in the range of
Conversion of binary no. (ex. .1101) to decimal
Metal oxide varistors are used for
What is unit of flux density?
Input is given to NAND gate then find out put
Problems on op-amp circuit
Problems on Nyquist plot to calculate angle
Two questions from microprocessor
Type of relay used in long transmission lines
Series capacitors are used for?
Which of the following machines works on Ac and DC supply
If sinusoidal input is given to Schimit trigger what will be output?
Calculate the RMS value of given voltage?
Special diode made of a metal & a semi-conductor?
Ratio of Electric field strength (E) & magnetic field (B) gives?
Roll -Off Characteristics for a Filter depends on?
Problems on Rth, to find Voltage across a given parameter in simple circuit
Problem to determine reactive power(Q) when Vs, Vr & X is given?
When Synchronous motor at no load?

ECIL GET Electrical And Electronics 2010

Which turbine used for low head
Two Transformer A & B have 50hz and 400hz frequency. Which is big A or B
What is the use of ready signal in 8085 microprocessors
Two lamp connected in series than total power drawn?
One question from synchronous motor
Calculate Rth of given ckt?
Two questions from Thevnin theorem
Amplifying Signal is carried by?
Calculate the frequency of parallel Resonance Circuit
One question from OPAM (calculate o/p voltage)?
Calculate load current of Bridge rectifier?
One program on C?
Calculate the Laplace of te^-at?
Given a characteristics equation of stable system find value of a?
When we used a negative feed back in Oscillator?
In CE configuration why Capacitor used parallel with resistor of emitter?
Which sensor not used for measurement of wight?
If sinusoidal input is given in vertical plate of CRO and nothing on horizontal what will happen?
Calculate the Time constant of RC circuit
Problems of circuit theory very simple
Thyristor will be turned off when